IMAGES TAKEN NEAR TO
Syke Lane, DEWSBURY, WF12 8HT
Introduction
This page details the photographs taken nearby to Syke Lane, WF12 8HT by members of the Geograph project.
The Geograph project started in 2005 with the aim of publishing, organising and preserving representative images for every square kilometre of Great Britain, Ireland and the Isle of Man.
There are currently over 7.5m images from over14,400 individuals and you can help contribute to the project by visiting https://www.geograph.org.uk
Image Map
Images are licensed for reuse under creativecommons.org/licenses/by-sa/2.0
Notes
- Clicking on the map will re-center to the selected point.
- The higher the marker number, the further away the image location is from the centre of the postcode.
Image Listing (68 Images Found)
Images are licensed for reuse under creativecommons.org/licenses/by-sa/2.0
Image
Details
Distance
1
Derelict Building - Syke Lane, Earlsheaton
Image: © Betty Longbottom
Taken: 27 Feb 2008
0.02 miles
2
Sykes Lane - viewed from Providence Street
Image: © Betty Longbottom
Taken: 26 Nov 2013
0.04 miles
3
Providence Mill, Earlsheaton No.3
The south facing façade of the 1820 mill building viewed from the Syke Lane entrance opposite Providence Street.
Image: © Bobby Clegg
Taken: 13 Sep 2015
0.04 miles
4
Providence mills, Earlsheaton
Home to a preserved horizontal tandem compound steam engine. This is steamed on rare occasions (last in 2008 - to date 12/09).
Image: © Chris Allen
Taken: 12 Nov 2000
0.04 miles
6
Providence Mill, Earlsheaton
This is a view of the original 1820 mill building from the Syke Lane side of the railings on top of the retaining wall.
Image: © Bobby Clegg
Taken: 13 Sep 2015
0.04 miles
7
Providence Mill, Syke Lane, Earlsheaton
Textile mill now used for fabric printing and home to a preserved horizontal tandem compound steam engine. The Ford Cougar was my wheels of the moment.
Image: © Chris Allen
Taken: 12 Nov 2000
0.05 miles
9
Skopos Fabrics, Earlsheaton - steam engine
The late Chris Evans restored the tandem compound steam engine at Providence Mill in the early 1980s and acquired other engines for display. This is a Marshall inverted vertical single cylinder that looks to have been used as a test engine. Its current location is unknown as the smaller engines from here were subsequently dispersed and the mill engine hasn't been run for many years.
Image: © Chris Allen
Taken: 12 Nov 2000
0.05 miles
10
Wm Greenwood, Providence Mills - steam engine
This horizontal tandem compound mill engine was disused in 1983 but was restored a few years later by Chris Evans and Paul Akrigg. It was then run on occasional open days but is now no longer regularly accessible and hasn't run for many years. It was built as a single cylinder engine by W & J Cardwell of Dewsbury (the only survivor) and compounded by Woodhouse & Mitchell of Brighouse. It is unusual in that it always appears to have run non-condensing.
I am not sure if it was on this visit that a group of us ran this engine after the boiler man asked us if we could run it. Fortunately one of our number had considerable experience in preserved stationary engine operation and we managed to safely warm it, oil it and run it for a few minutes. Being non-condensing made it relatively docile even off load.
A restored view can be seen here - Image
Image: © Chris Allen
Taken: 14 Dec 1983
0.06 miles