IMAGES TAKEN NEAR TO
Williams Terrace, SUNDERLAND, SR2 0HT

Tunstall old fire station, Burdon Lane, Tunstall, Tyne & Wear, now used as the Blue Watch Youth Centre

Very few visitors are likely to ever see this single cylinder geared winch that is tucked under the entrance steps to the engine house. Built by M Coulson & Co of Spennymoor in 1890. The slide valve cylinder is c14" x 24" and the flywheel is 5' diameter. It has Stephenson link reversing motion and a worm drive to the winch drum.

Very few visitors are likely to ever see this single cylinder geared winch that is tucked under the entrance steps to the engine house. Built by M Coulson & Co of Spennymoor in 1890. The slide valve cylinder is c14" x 24" and the flywheel is 5' diameter. It has Stephenson link reversing motion and a worm drive to the winch drum.

This site is now a museum. This shows the beams of the two Woolf compound beam pumping engines built by R & W Hawthorn in 1868. The beams are each 33' long between end centres and weigh 22 tons. This view is from the crank end of the beams with the parallel motion operating the well pumps with a stroke of 10' 8". The connecting rod picks up inboard of the pumps with an 8' stroke to the crank.

What can one say! This has been described as "The finest industrial monument in the north-east". Victorian waterworks with preserved and workable beam engines and Lancashire boilers.

What can one say! This has been described as "The finest industrial monument in the north-east". Victorian waterworks with preserved and workable beam engines and Lancashire boilers.

This shows part of one of the two Woolf compound beam engines built in 1868 by R & W Hawthorn and in use until 1967. The cylinders are 27.5" x 5'4" and 45" x 8'. The beams are 33' between end centres and weigh 22 tons. The flywheels are 24' diameter and weigh 18 tons. The engines used steam at 35 psi, ran at 10 rpm and delivered 40,000 gallons per hour against a 243' head. This is a view down the main well with the 4' throw crank in the foreground. Beyond is the drive to the main well pump with its 10' 8" stroke. This pump lifted the water from about 250' below the engine house floor to 130' below the floor from where it flowed to the staple well at the opposite end of the engine. A pump at the other end of the engine then lifted it to the reservoir at ground level. Having pumps at each end balanced the loading across the engine's centre.

This shows one of the two Woolf compound beam engines built in 1868 by R & W Hawthorn and in use until 1967. The cylinders are 27.5" x 5'4" and 45" x 8'. The beams are 33' between end centres and weigh 22 tons. The flywheels are 24' diameter and weigh 18 tons. The engines used steam at 35 psi, ran at 10 rpm and delivered 40,000 gallons per hour against a 243' head.